3M™ Clean-Trace™ NG Luminometer
3M™ Clean-Trace™ Surface ATP UXL100 is a single-use test device that contains a swab for the collection of a sample from a surface. The swab is pre-moistened to aid in sample collection and processing.
Upon activation of the test, the chemical reacts with the sample collected on the swab to produce light. The amount of the light produced is proportional to the degree of potential contamination. Measurement of the light requires the use of a 3M™ Clean-Trace™ NG Luminometer and the results are displayed in Relative Light Units (RLU). The higher the RLU number, the more contaminated the sample. Not intended for consumer use.
Availability: Commercially Available
Mark Burch
Marketing Manager
mburch@mmm.com
+1 913 526 3034
3M Center, Building 275-5W-05
St. Paul, MN 55144-1000
USA
|
+1 800 328 6553
|
3M.com
| Manufacturer |
| 3M |
| Product Name |
| 3M™ Clean-Trace™ NG Luminometer |
| Detection Category |
| Biological |
| Detection Principle |
| Immunological; |
| Detection Method |
| Electrochemiluminescence; |
| Application |
| Detection; |
| Product Model Number |
| LM1
UXL100 (swabs) |
| Equipment Type |
| Instrument |
| Product Synopsis |
| 3M™ Clean-Trace™ Surface ATP UXL100 is a single-use test device that contains a swab for the collection of a sample from a surface. The swab is pre-moistened to aid in sample collection and processing.
Upon activation of the test, the chemical reacts with the sample collected on the swab to produce light. The amount of the light produced is proportional to the degree of potential contamination. Measurement of the light requires the use of a 3M™ Clean-Trace™ NG Luminometer and the results are displayed in Relative Light Units (RLU). The higher the RLU number, the more contaminated the sample. Not intended for consumer use. |
| Availability |
| Commercially Available |
| Technology Readiness Level (TRL) |
| 9 |
| User Feedback Sources |
| Indifferent/No user feedback |
| Dimensions |
| 10.56 x 2.33 x 3.48 in (h x l x w) |
| Weight |
| <30 lbs. |
| Power Requirements |
| Lithium Battery |
| Noise Produced |
| Negligible |
| Transportability |
| Handheld |
| Ruggedness |
| Vibration/Shock; impact-resistant casing |
| Operating Conditions |
| 5-40°C (41-104 °F) |
| Consumables |
| <$1,000/year; swabs |
| Solvents/Reagents |
| None |
| Calibration Schedule |
| Self-diagnostic check on start-up |
| Available Accessories |
| None |
| Data Analysis Support Equipment |
| PC, Software-3M Quality Control Data Manager |
| Communications Interface |
| Bluetooth, USB |
| Expected Operational Life |
| 5 to 10 years |
| Shelf Life |
| <1 year; Swabs: 10 months |
| Unit Cost |
| $2,900.00 |
| Tested For Biological Agents |
| All live bacteria |
| Other Biological Targets |
| All live bacteria |
| Adaptability |
| No; cannot detect or add new targets |
| Sample Introduction |
| Liquid;Solid; |
| Start Up Time (From Cold Start To Sample Ready) |
| 10 minutes |
| Response Time (Sample Application To Output) |
| <5 minutes |
| Total Run Time |
| 12-15 minutes |
| Software Control |
| On-board |
| Training Required |
| <1 day training |
| Training Available |
| Yes |
| Manuals Available |
| Yes |
| Reachback Service |
| No |
| IATA Shipping Restrictions |
| No |
| Approved Vendors |
| 3M, Grainger, Zoro |
