RCO1000, RH2S100, RNO2100
The nanotechnology enabled and patented TTI R-series sensor is a three electrode electrochemical sensor for CO (0-1000 ppm), H2S (0-100 ppm), or NO2 (0-100 ppm). While available in the standard configuration, the pin configuration can be customized to match virtually any customer specification. These sensors are based on a design that has been proven for over 10 years in the field and have the highest reliability of any electrochemical sensor.
Availability: Commercially Available
| Manufacturer |
| KWJ Engineering |
| Product Name |
| RCO1000, RH2S100, RNO2100 |
| Detection Category |
| Chemical |
| Detection Principle |
| Sensors; |
| Detection Method |
| Electrochemical Detection ; |
| Application |
| Emergency Response; Gas Analysis; |
| Equipment Type |
| Sensor |
| Product Synopsis |
| The nanotechnology enabled and patented TTI R-series sensor is a three electrode electrochemical sensor for CO (0-1000 ppm), H2S (0-100 ppm), or NO2 (0-100 ppm). While available in the standard configuration, the pin configuration can be customized to match virtually any customer specification. These sensors are based on a design that has been proven for over 10 years in the field and have the highest reliability of any electrochemical sensor. |
| Availability |
| Commercially Available |
| Technology Readiness Level (TRL) |
| 9 |
| User Feedback Sources |
| Indifferent/No user feedback |
| Dimensions |
| 1.26 x .8 in (32 x 20.4 mm) |
| Weight |
| <1 lb.; 10 g |
| Transportability |
| Pocket Size |
| Operating Conditions |
| 20 to 50°C (operating temperature) 0 to 35°C (recommended operating temperature) 22°C (recommended storage temperature) 15 – 90% Relative Humidity, operating 60 – 80% Relative Humidity, storage |
| Shelf Life |
| <1 year |
| Other Chemical Targets |
| Carbon Monoxide (RCO1000), Hydrogen Sulfide (RH2S100), Nitrogen Dioxide (RNO2100) |
| Sample Introduction |
| Vapor/Gas |
| Sensitivity/Detection Limits |
| ppm |
| Known Interferents/Inhibitors |
| Has a filter to reduce interferents |
| Start Up Time (From Cold Start To Sample Ready) |
| 15 minutes after first installation; thereafter < 30 seconds |
| Response Time (Sample Application To Output) |
| Continuous (<30 seconds); T(90)<30 seconds typical at 20 C |
| Alarm Capability |
| Output signal |
| Training Required |
| <1 hour training |
| Manuals Available |
| Yes – Spec sheets |
| Warranties |
| 1 year, extended warranty available |
