CO-MFS, H2S-MNS, NO-MFS, NO2-MNS
This three electrode electrochemical sensor indicates 0-1000 ppm CO, 0-500 ppm H2S, 0-1000 ppm NO, or 1-10 ppm NO2with integrated high-capacity interference filter was developed for use in the probe of an indoor air quality (IAQ) meter.
Availability: Commercially Available
| Manufacturer |
| KWJ Engineering |
| Product Name |
| CO-MFS, H2S-MNS, NO-MFS, NO2-MNS |
| Detection Category |
| Chemical |
| Detection Principle |
| Sensors; |
| Detection Method |
| Electrochemical Detection ; |
| Application |
| Emergency Response; Gas Analysis; |
| Equipment Type |
| Sensor |
| Product Synopsis |
| This three electrode electrochemical sensor indicates 0-1000 ppm CO, 0-500 ppm H2S, 0-1000 ppm NO, or 1-10 ppm NO2with integrated high-capacity interference filter was developed for use in the probe of an indoor air quality (IAQ) meter. |
| Availability |
| Commercially Available |
| Technology Readiness Level (TRL) |
| 9 |
| User Feedback Sources |
| Indifferent/No user feedback |
| Dimensions |
| .625 x 1.1 in (15.9 x 27.9 mm) |
| Weight |
| <1 lb.; 5 g |
| Transportability |
| Pocket Size |
| Operating Conditions |
| 0 to 45°C (temperature continuous) -20 to 55°C (temperature intermittent) 15 – 90% Relative Humidity, non-condensing, continuous 0 – 99% Relative Humidity, non-condensing, intermittent |
| Shelf Life |
| <6 months |
| Other Chemical Targets |
| Carbon Monoxide (CO-MFS), Hydrogen Sulfide (H2S-MNS), Nitric Oxide (NO-MFS), Nitrogen Dioxide (NO2-MNS) |
| Sample Introduction |
| Vapor/Gas |
| Sensitivity/Detection Limits |
| ppm; ppb |
| Response Time (Sample Application To Output) |
| <1 minute; <60 seconds to 90% Full Signal; Typical is 20 seconds |
| Alarm Capability |
| Output signal |
| Training Required |
| <1 hour training |
| Manuals Available |
| Yes – Spec sheets |
