Sensepoint Flammable and Toxic Gas Detector
The Sensepoint flammable, toxic and Oxygen gas detectors offer users a low cost solution to their industrial gas monitoring needs. Installation in potentially explosive atmospheres is made by the use of a suitable Exd or Exe approved junction box. The industry standard outputs from Sensepoint are connected to either a choice of Honeywell Analytics’ controllers or 3rd party DCS / PLC systems. Both flammable and toxic versions are certified to the latest European ATEX safety and performance standards. The flammable detector is available in either % LEL or PPM detection range versions and provides an industry standard mV bridge output. Typical life expectancy is greater than 5 years, after which the detector is simply replaced with a new one.
Availability: Commercially Available
| Manufacturer |
| Honeywell Analytics |
| Product Name |
| Sensepoint Flammable and Toxic Gas Detector |
| Detection Category |
| Chemical |
| Detection Principle |
| Sensors; |
| Detection Method |
| Electrochemical Detection ; |
| Application |
| Emergency Response; Gas Analysis; |
| Equipment Type |
| Sensor |
| Product Synopsis |
| The Sensepoint flammable, toxic and Oxygen gas detectors offer users a low cost solution to their industrial gas monitoring needs. Installation in potentially explosive atmospheres is made by the use of a suitable Exd or Exe approved junction box. The industry standard outputs from Sensepoint are connected to either a choice of Honeywell Analytics’ controllers or 3rd party DCS / PLC systems. Both flammable and toxic versions are certified to the latest European ATEX safety and performance standards. The flammable detector is available in either % LEL or PPM detection range versions and provides an industry standard mV bridge output. Typical life expectancy is greater than 5 years, after which the detector is simply replaced with a new one. |
| Availability |
| Commercially Available |
| Technology Readiness Level (TRL) |
| 9 |
| User Feedback Sources |
| Indifferent/No user feedback |
| Weight |
| <1 lb.; 6.7 oz (190 g) |
| Transportability |
| Pocket Size |
| Ruggedness |
| Extreme Temperatures/Humidity |
| Operating Conditions |
| -20 to 40°C (-4 to 105°F); 90 to 110 kPa Operating Pressure; 20 to 90%RH |
| Consumables |
| <$1,000/year; Replacement sensors |
| Available Accessories |
| Weatherproof cap, Flow adaptor, Duct mounting kit, Collecting cone |
| Communications Interface |
| 4 to 20 mA 2/3 Wire |
| Shelf Life |
| >5 years; <6 months; Flammable sensors typically over 5 years when in original sealed packaging All other sensors 6 months |
| Unit Cost |
| $500.00 |
| Tested For Chemical Agents |
| No |
| Tested For ITF-25 TIC/TIMs |
| No |
| Tested For Explosives |
| No |
| Tested For Narcotics |
| No |
| Other Chemical Targets |
| Hydrogen Sulfide, Carbon Monoxide, Ammonia, Chlorine, Oxygen, Hydrogen, Sulfur Dioxide, Nitric Oxide, Nitrogen Dioxide, Flammable |
| Sample Introduction |
| Vapor/Gas |
| Sensitivity/Detection Limits |
| %LEL |
| Start Up Time (From Cold Start To Sample Ready) |
| Varies by gas typically under 20 minutes; however, Nitrogen Oxide takes 12 hours and Nitrogen Dioxide takes 1 hour |
| Response Time (Sample Application To Output) |
| <5 minutes; < 90 seconds |
| Alarm Capability |
| No |
| Software Control |
| Yes |
| Training Required |
| <1 week training |
| Manuals Available |
| Yes |
