MF010 Oxygen Sensor
Two Zirconium dioxide discs have a hermetically sealed between them. One disc acts as a pump to fill and empty the chamber. The second measures the ratio of the partial pressure difference and generates a corresponding voltage. More specifically the time it takes for the pump to reach specific minimum and maximum pressures is a measure of the partial pressure of oxygen.
Availability: Commercially Available
Chris Dillman
Digi Key Sales Rep
800-344-4539 ext: 2315
701 Brooks Avenue South
River Falls, MN 56701 USA
|
|
www.DigiKey.com
| Manufacturer |
| Digi-Key Corporation |
| Product Name |
| MF010 Oxygen Sensor |
| Detection Category |
| Chemical |
| Detection Principle |
| Sensors; |
| Detection Method |
| Electrochemical Detection ; |
| Application |
| Emergency Response; Gas Analysis; |
| Product Model Number |
| 480-2092-ND |
| Equipment Type |
| Sensor |
| Product Synopsis |
| Two Zirconium dioxide discs have a hermetically sealed between them. One disc acts as a pump to fill and empty the chamber. The second measures the ratio of the partial pressure difference and generates a corresponding voltage. More specifically the time it takes for the pump to reach specific minimum and maximum pressures is a measure of the partial pressure of oxygen. |
| Availability |
| Commercially Available |
| Technology Readiness Level (TRL) |
| 9 |
| User Feedback Sources |
| Indifferent/No user feedback |
| Dimensions |
| 4.2 x 1.7 x 2.4 in (105 x 42 x 60 mm) |
| Weight |
| <1 lb.; 5.3 oz (150 g) |
| Power Requirements |
| AC/DC Line Power; 24 VDC |
| Transportability |
| Pocket Size |
| Operating Conditions |
| -100 to 250°C (temperature of gas being measured) -10 to 50°C (ambient conditions) |
| Calibration Schedule |
| Yes |
| Data Analysis Support Equipment |
| Circuit boards, gas sensor modules |
| Communications Interface |
| Used with circuitry and datalogging software |
| Unit Cost |
| $2,727.00 |
| Sample Introduction |
| Vapor/Gas |
| Sensitivity/Detection Limits |
| %; 0.1 to 25% oxygen or 0.1 to 100% oxygen |
| Response Time (Sample Application To Output) |
| Continuous (<30 seconds); ~3 seconds |
| Software Control |
| Can be used with data loggers |
| Other Operational Parameters |
| Output is either 0-10 VDC or 4-20 mA |
| Training Required |
| >1 week training |
| Training Available |
| Training module can be acquired through Digikey website |
| Manuals Available |
| Sensor line guide on the Honeywell website |
| Warranties |
| Yes |
